Hitachi DKC910I Installation Section page 27

Hitachi Proprietary
Rev.1
INST(IN)02-03-110
6. Installation of Side Covers
Paying attention to falls:
Dropping a side cover may cause injury.
When installing or removing the side cover, hold the cover firmly with both hands and be
careful not to drop it on your feet. Make sure the side cover is hung on the hook of the rack
frame side when it is installed.
NOTE: • When installing the side covers, install them in order from the lower part.
(1) Hang the hook of the side cover on the lower part of the left side of the rack frame, slide the side
cover to the front of the rack frame, and then secure the side cover with the four screws  and the
two screws .
(2) Hang the hook of the side cover on the upper part of the left side of the rack frame, slide the side
cover to the front of the rack frame, and then secure the side cover with the four screws  and the
two screws .
(3) Install the side covers on the right side of the rack frame in the same way.
Figure 2-15 Attachment of Side Covers
Screw  × 2
(SB406N)
Side Cover
Side Hook
Screw  × 4
(SB408NB)
Hook
Side Hook
Hook
Side Cover
Screw  × 4
(SB408NB)
• When removing the side covers, remove them in order from the upper part.
Rack Frame
Copyright © 2019, 2021, Hitachi, Ltd.
Front View
[INST(IN)02-03-110]
DKC910I