Mounting Storage System On Rack Frame - Hitachi DKC910I Installation Section

Hitachi Proprietary
Rev.1
INST(IN)06-02-10

6.2 Mounting Storage System on Rack Frame

If the Storage System falls when the elevator of the lifter is at a high position, a personal injury
will be caused.
Perform the positioning, fastening, or other handlings very carefully.
• Rack mounting and lifter operation should only be conducted by a person who has been
trained and qualified since the Storage System could turn over or a worker could be caught
under the Storage System.
• Operate the valve slowly when opening it. If it is opened quickly, the elevator of the lifter
descends rapidly and may cause personal injury.
• Be sure to perform the operation with two or more workers.
• Work carefully because the mass of the single DKC is about 75 kg, SBX is about 24 kg, UBX is
about 27 kg, FBX is about 38 kg, NBX is about 21 kg, and HSNBX is about 15 kg.
• Be sure to install it in order from the bottom to prevent the falling of the rack when you install
the Storage System on the rack.
1. Take off the stopper of the special lifter on which the Storage System has been put, and move the lifter
close to the rack frame.
2. Adjust the position of the Storage System so that it is seated in the center of the rack frame.
Be careful not to lift the elevating base too high. If you lift it too high, lower it by opening the up/down
valve gently.
3. Remove the band and adjust the position of the Storage System so that the Storage System comes in the
center in front of the rack frame.
If the Storage System is positioned off-centered, a screw contacts the Front Bezel preventing the front
bezel from being opened or closed.
Do not move the lifter away from the rack frame nor lower the elevator until the red line on the
label affixed on the Storage System enters the rack frame across the end of it. Otherwise, falling
of the Storage System may be caused.
4. Shift the Storage System onto the rails in the rack frame. When shifting the Storage System, push it in to
the end gently.
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
[INST(IN)06-02-10]