Hitachi DKC910I Installation Section page 160

Hitachi Proprietary
Rev.2
INST(IN)09-04-90
(1) Connect the cables to the OUT ports according to Figure 5-1
(LOC05-11). Eight cables need to be connected for VSP 5100 and 5100H, while 16 cables need to
be connected for VSP 5500 and 5500H.
Example of the cable : Connect the cable to which the red label is attached to the DKB-01H 0
port (red label
(2) Connect the cables to the IN ports on DBs according to Figure 5-3 (LOC05-20). Eight cables need
to be connected for VSP 5100 and 5100H, while 16 cables need to be connected for VSP 5500 and
5500H.
Example of the cable : Connect the cable to which the red and white label is attached to the
ENC000-1 IN0 port (red and white label
If there is another SBX/UBX/FBX in the configuration, perform
NOTE: The number of NBX that can be installed is one.
Figure 9-37 SAS Cable/NVMe Cable Connection
The connection for SBX is illustrated in the figure below. The connection for FBX/NBX is also the
same.
For Copper Cable
Red and white label ENC (SBX)
Red label
Copper Cable
For Optical Cable
Red and white label
Optical Cable
).
DKB
ENC (SBX)
DKB
Red label
(LOC05-10)
).
Step (3) and later.
ENC000-1
Red and white label
DKB-01H
Red label
ENC000-1
Red and white label
DKB-01H
Red label
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
or Figure 5-2
[INST(IN)09-04-90]