Hitachi DKC910I Installation Section page 83

Hitachi Proprietary
Rev.2
INST(IN)07-02-20
1. Fixing the front side of the Drive Box
NOTE : Use parts of the rail for the fixing screw and other products. (Refer to
(1) Install the Drive Box on the front side of the Rack frame.
(2) For SBX/UBX
From the rear of the rack, check whether the nuts (stoppers) fit the parts of the Drive Box as shown
in the figure below.
If the positions of the nuts (stoppers) are not correct, remove the Drive Box, and correct the
positions of them.
For NBX
From the rear of the rack, check whether the stoppers fit the parts of the Drive Box as shown in the
figure below.
If the positions of the stoppers are not correct, remove the Drive Box, and reinstall it in the correct
position. (The stopper of the rail for NBX is fixed to the rail and is not adjustable.)
Figure 7-5 Checking the Rear Side of the Drive Box
Nut (stopper)
Rear view of SBX/UBX
Stopper
Rail
Rail
Rear view of NBX
Rear view
Rail
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
Table 3-2.)
Nut (stopper)
Rail
Rear view of SBX/UBX
[INST(IN)07-02-20]