Hitachi DKC910I Installation Section page 90

Hitachi Proprietary
Rev.2
INST(IN)07-04-30
(4) Fix the stopper (L) with the two binding screws while pressing it downward.
(5) Fix the stopper (R) with the two binding screws while pressing it downward.
Figure 7-16 Fixing Stoppers
Pressing the stopper
downward
Pressing the stopper downward
Binding
screws
(6) Check that the top surface of the Controller Chassis is fit on the stopper (L) and the stopper (R)
without gaps.
(The stoppers might be rotated and raised by tightening the binding screws.)
NOTE: When the installation of the stoppers is difficult because the space between the
Rear view of rack
Loop cable tie
Stopper (L)
Controller Chassis and the Chassis above it is too narrow, contact the Technical
Support Division to resolve the problem.
Pressing the stopper
downward
Pressing the stopper downward
Loop cable tie
Stopper (R)
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
Binding
screws
[INST(IN)07-04-30]