Hitachi DKC910I Installation Section page 45

Hitachi Proprietary
Rev.2
INST(IN)03-01-113
(5) Tighten the screw (SBB-RAIL) and the loop cable tie on the rear edge of the rail to fix the rail to
the rack. The fixing position is the fourth hole from the bottom of the unit boundary line.
Figure 3-14 Fixing the Rails
Right side of rack
Screw (SBB-RAIL)
Loop cable tie
(6) Install a rail (L) on the left side of the rack in the similar procedure.
Loop cable tie
Frame (rear right side)
Unit boundary
Unit boundary
Unit boundary
Screw (SBB-RAIL)
Copyright © 2019, 2021, Hitachi, Ltd.
Rail
Frame (front right side)
[INST(IN)03-01-113]
DKC910I