Hitachi DKC910I Installation Section page 101

Hitachi Proprietary
Rev.0
INST(IN)08-02-30
(5) Install four BKMFs in the Controller Board.
(a) Keep the lever of BKMF pulled down toward you.
(b) Insert the BKMF up to the front of the shield finger.
(c) Insert the BKMF while pushing the side of its lever to the left until the pin of the lever goes
through the cutout of the chassis and stops.
(d) Raise the BKMF lever and tighten the screws (blue) and fix it.
Figure 8-9 Installing BKMF (DKC)
BKMF (FANM)
Screw (blue)
Side of lever
Pin
Shield finger
Lever
Cut
DKC
BKMF (FANM)
BKMF
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
[INST(IN)08-02-30]