Hitachi DKC910I Installation Section page 33

Hitachi Proprietary
Rev.2
INST(IN)03-01-40
1. Installing rails for Controller Chassis
The rail install procedure is different depending on the hole shape (square or circular hole) on the rack.
Check the holes on the rack before the installation work.
Table 3-1 shows the components for the rails for Controller Chassis.
Table 3-1 Components for Rail (DW-F800-RRCB/DKC-F910I-RRCBE) (Per Unit)
Item No. Product name
1 Rail
2 Screw etc
3 Rack nut
4 Cage nut
5 KS-PIN
Binding screw (M5 × 10)
6
7 LL washer (M5)
8 Loop cable tie
*1 : 2 spares are included.
*2: These parts are included in Item No. 2 Screw etc.
When installing the rails to a rack with circle holes, replace the right and left pins (total of eight places)
on the front and rear sides with the supplied circular hole pins (KS-PINs).
Figure 3-4 Replacing Square Hole Pins
Parts No.
2855180-A
2857743-A
5510146-1
5528564-1
5557433-1
SB510N
5513553-513
5552567-1
Rail
For square hole
Quantity
1 set Rail (R) and Rail (L)
− 1
4 (*1) For fixing Storage System and
rail
4 (*1) For fixing Storage System and
rail
8 (*1) Pin for circular hole
8 (*1) For fixing rail and Storage System (*2)
4 (*1) For fixing rail (for square hole)
2 For fixing the cable
For circle hole
(KS-PIN)
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
Comment Remarks
−
(*2)
(*2)
(*2)
(*2)
[INST(IN)03-01-40]
−
−
−