Hitachi DKC910I Installation Section page 42

Hitachi Proprietary
Rev.2
INST(IN)03-01-110
(3) Loosen the four screws on the side of the rail (R) and adjust the rail (R) length.
When the rack frame and the rail width do not match even if loosening the screws, remove the four
screws, adjust the length, and then fix the rail with four screws again.
(4) Fit the positioning pins (at three places in front and rear) in the holes in the position to be installed
on the right side of the rack.
(5) Close the clips on the rail (R) and install the rail (R) in the rack.
(6) Tighten the four screws on the side of the rail (R).
(7) Fix the rear side of rail (R) with screw and loop cable tie. The fixing position is the third hole from
the bottom of the unit boundary line.
(8) Install a rail (L) on the left side of the rack in the similar procedure.
Figure 3-11 Installing Rails
Frame (Rear view)
Loop cable tie
Screw
Clip
Positioning pin
Unit boundary
1 Unit
Unit boundary
1 Unit (*1)
Unit boundary
*1: Lowest unit of installing position Unit
1 Unit
1 Unit
Four screws
Rail (R)
Positioning pin
Screw
Positioning pin
Rear
Loop cable tie
Frame (Front view)
Positioning pin
Clip
Positioning pin
Unit boundary
1 Unit
Unit boundary
1 Unit (*1)
Unit boundary
Front
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
1 Unit
1 Unit
[INST(IN)03-01-110]