Hitachi DKC910I Installation Section page 40

Hitachi Proprietary
Rev.2
INST(IN)03-01-90
(9) Tighten the screw (SBB-RAIL) and the loop cable tie on the rear edge of the rail to fix the rail to
the rack. The fixing position is the fourth hole from the bottom of the unit boundary line.
Figure 3-9 Fixing the Rails
Right side of rack
(10) Install the rail into the left side of the rack in the same way as procedures
The right and left rails are same in shape. Horizontally turn the left rail in the opposite direction of
the right rail (180 degree turn).
3. Installing rails for Drive Box (FBX)
The rail install procedure is different depending on the hole shape (square or circular hole) on the rack.
Check the holes on the rack before the installation work.
Table 3-3 shows the components for the rails for Drive Box (FBX).
Table 3-3 Components for Rail (RRDBF) (Per Unit)
Item No. Product name
1 Slide Rail
2 Accessory Set
3 Screw
4 Screw (M4_FLAT)
5 Loop cable tie
*1: These parts are included in Item No. 2 Accessory Set.
Unit boundary
Unit boundary
Unit boundary
Screw (SBB-RAIL)
Loop cable tie
Parts No.
2854551-A
3261898-512
5550657-A
5552567-1
Frame (rear right side)
Rail
Quantity
1 set Rail(R) and Rail(L)
−
1
4 For fixing Storage System and
rail
6 Pin for rectangular hole
2 For fixing the cable
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
Frame (front right side)
Step (6) to Step (9).
Comment Remarks
−
(*1)
(*1)
[INST(IN)03-01-90]
−
−
−