Fastening Storage System; Fixing Controller Chassis - Hitachi DKC910I Installation Section

Hitachi Proprietary
Rev.4.2
INST(IN)07-01-10

7. Fastening Storage System

NOTE: If you use rails other than Hitachi Vantara rails, check that screws securing the rails,
NOTE: If you use Hitachi Vantara rails, Hitachi Vantara washer sets are necessary.

7.1 Fixing Controller Chassis

Table 7-1 Front Bezel Components List (Per One Unit)
Item No.
1 Front Bezel
2 Binding Screw (M5 × 10)
1. Checking stoppers.
• For the rail type without a stopper, go to
• For the rail type with a stopper, check that the rear right and left of the bottom of the Controller Chassis
are fit in the stoppers (see
install the Controller Chassis properly.
Go to Step 2.
Figure 7-1 Checking Stoppers on the Rear Side (for Rail Type with a Stopper)
Stopper
and the like, are not protruded from the rack surface on which to install the Controller
Chassis and that the rack surface is flat (see "Notes for Installing Controller Chassis"
(INST(GE)01-01-50)).
Be sure to use the washers.
Parts name Parts No.
5559126-A
SB510N
Figure 7-1). When the Controller Chassis is disengaged from the stoppers,
Rack frame (rear view)
Quantity
1
8
Step 2.
Stoppers
Copyright © 2019, 2021, Hitachi, Ltd.
Comment
Front Bezel (DKC)
For fixing the Controller Chassis
and the bracket
Stopper
[INST(IN)07-01-10]
DKC910I