Hitachi DKC910I Installation Section page 118

Hitachi Proprietary
Rev.0.5
INST(IN)09-01-80
2. Pull all the Fibre Channel cables into the rack frame passing them through an opening for cables on the
bottom plate of the rack frame.
3. Connect the Fibre Channel cable to the connector of the each port.
NOTE : • Insert the Fibre Channel cables until they are fixed to the Small Form-Factor
4. Fix the Fibre Channel cables with binders giving them excessive lengths.
If the length of the Fibre Channel cables is too long, put the extra cable length outside the rack.
Figure 9-6 Optical Fibre Channel Routing in the RKU Rack Frame
Cable passing opening
Rear view of Rack Frame
Pluggable (SFP).
If the Fibre Channel cables are inserted half in the Small Form-Factor Pluggable
(SFP), the Controller Board continues to detect the Fibre Channel cable failures, and
the I/O processing of the Controller Board may be deteriorated.
• The location of Fibre Channel cable connectors is different depending on Controller
Board. Check the location before connecting a cable.
• Check that Fibre Channel cable latch clicks and the cables are surely connected.
DKC
Binder
Copyright © 2019, 2021, Hitachi, Ltd.
Fibre Channel cables
[INST(IN)09-01-80]
DKC910I