Hitachi DKC910I Installation Section page 43

Hitachi Proprietary
Rev.2
INST(IN)03-01-111
4. Installing rails for Drive Box (NBX)
The rail install procedure is different depending on the hole shape (square or circular hole) on the rack.
Check the holes on the rack before the installation work.
Table 3-4 shows the components for the rails for Drive Box (NBX).
Table 3-4 Components for Rail (RRNB) (Per Unit)
Item No.
1 Slide Rail
2 Screw (SBB-RAIL)
3 Pin Screw
4 Loop cable tie
*1: These parts are included in Slide Rail (Item No.1).
NOTE: Front rails have two types; (R) and (L). Check that with the marking on the rail.
(1) When the rack installation hole is circular, replace positioning pin with the supplied pin screw ( φ
6.8 head screw). When the rack installation hole is rectangular, go to
screw ( φ 9.2 head screw) as is).
Figure 3-12 Work before Installing Rails
Positioning pin
Part Name
2853847-E
5552567-1
These rails extend or shorten back and forth.
Positioning pin
Rail (R)
Part No. Quantity
1 set
−
4
−
8
2
Copyright © 2019, 2021, Hitachi, Ltd.
Comment
Rail (R) and Rail (L)
−
Pin for circular hole
For fixing the cable
Step (2) (remain the guide
Positioning pin
Positioning pin
[INST(IN)03-01-111]
DKC910I
Remarks
−
(*1)
(*1)
−