Hitachi DKC910I Installation Section page 41

Hitachi Proprietary
Rev.0.1
INST(IN)03-01-100
NOTE: • Front rails have two types; (R) and (L). Check that with the marking on the rail.
(1) Open two clips on the front and back of the rail (R).
(2) When the rack installation hole is rectangular, replace positioning pins ,  and  with the
supplied screws (M4 FLAT) ( φ 9.2 head screw).
Figure 3-10 Work before Installing Rails
Positioning pin 
Clip
In case of square hole
Screw (M4 FLAT)
• These rails extend or shorten back and forth.
Rail (R)
Positioning pin 
Copyright © 2019, 2021, Hitachi, Ltd.
Positioning pin 
Clip
Positioning pin 
[INST(IN)03-01-100]
DKC910I