Driven Clutch Installation - Polaris RZR PRO XP 2020 Service Manual

7. Install the stationary and movable sheave on the
vehicle. See Driven Clutch Installation.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.

DRIVEN CLUTCH INSTALLATION

1. Install the driven clutch on the transmission input
shaft.
q w
2. Install shim , washer , and driven clutch retaining
e
bolt . Torque bolt to specification.
TORQUE
Driven Clutch Retaining Bolt:
43 ft-lbs (58 Nm)
3. With the clutch spreader tool installed, loop the belt
over the drive clutch and over part of the driven
clutch. Be sure to install belt in the direction
previously marked.
4. Rotate the driven clutch and walk the belt into the
clutch.
5. Remove the clutch spreader tool from the driven
clutch.
6. Rotate / spin the driven clutch and belt approximately
5-7 times to properly seat the belt in the driven clutch.
7. Install the outer clutch cover and fourteen fasteners
r
. Torque fasteners to specification.
TORQUE
Outer Clutch Cover Fasteners:
36 in-lbs (4 Nm)
PVT SYSTEM
6
6.37