Driven Clutch Alignment - Polaris RZR PRO XP 2020 Service Manual

PVT SYSTEM
8. Install PVT intake hose, and torque hose clamp
specification.
TORQUE
PVT Intake Hose Clamp:
25 in-lbs (3 Nm)

DRIVEN CLUTCH ALIGNMENT

Most vehicles require four to six alignment washers (PN
7557060) for proper alignment. As many as eight
alignment washers or as few as zero may be used.
IMPORTANT
The main washer directly under the head of the bolt
must always be used.
1. Remove the outer clutch cover from the vehicle.
2. Rotate the driven clutch clockwise several times
before inspection.
3. Inspect where the belt is riding on the drive clutch.
NOTICE
A mobile device can be used to capture a picture of the
belt tracking to determine if adjustment is needed.
4. Remove the drive belt.
6.38
t
to 5. Remove the Driven Clutch Bolt and washer.
q
6. Add shims
sheave of the drive clutch, or remove shims to move
the belt closer to the outer sheave of the drive clutch.
Ensure the driven clutch splines and transmission
splines and shaft are clean and free of debris.
7. Reinstall the washers and Driven Clutch Bolt. Torque
to specification.
When finished, the driven clutch should not rotate on its
own, or should stop with minimal drag when using a
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
to move the belt closer to the inner
IMPORTANT
TORQUE
Driven Clutch Bolt:
43 ft-lbs (58 Nm)
NOTICE
new bearing.
© Copyright Polaris Industries Inc.