Polaris RZR PRO XP 2020 Service Manual page 492

BRAKE SYSTEM
BRAKE BLEEDING / FLUID CHANGE
IMPORTANT
Bleed the right rear caliper first, followed by the left rear,
front right, and finally the front left caliper.
Always wear safety glasses when handling chemicals
and fluids.
Brake fluid will damage finished surfaces. Do not allow
brake fluid to come in contact with finished surfaces.
1. Clean master cylinder reservoir cover thoroughly and
w
remove the cover .
2. If changing fluid, remove old fluid from reservoir
with a Mity Vac™ pump or similar tool.
Mity Vac™:
2870975
10.14
CAUTION
CAUTION
3. Add brake fluid to the indicated MAX level of
reservoir.
Polaris DOT 4 Brake Fluid
4. Bleed the brakes in the following order: right rear, left
rear, right front and finally the left front. Install a box
end wrench on caliper bleeder screw. Attach a clean,
clear hose to fitting and place the other end in a
clean container. Be sure the hose fits tightly on
fitting.
5. Have an assistant slowly pump foot pedal until
pressure builds and holds.
6. Hold brake pedal down to maintain pedal pressure,
and open bleeder screw
bleeder screw and release pedal.
q
Do not release foot pedal before bleeder screw is tight
or air may be drawn into the brake system.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
2872189
e
one full turn. Close
NOTICE
© Copyright Polaris Industries Inc.