Button To Tower Clearance Inspection; Spider Removal; Roller, Pin, And Thrust Washer Inspection - Polaris RZR PRO XP 2020 Service Manual

PVT SYSTEM
BUTTON TO TOWER CLEARANCE
INSPECTION
1. Inspect for any clearance between spider button to
tower. If clearance exceeds specification, replace all
buttons and inspect surface of towers. Refer to
Spider Removal page 6.12 procedure.
Button to Tower Clearance:
0.000 - 0.020"
2. Inspect sheave surfaces. Replace the entire clutch if
worn, damaged or cracked.

SPIDER REMOVAL

1. Remove the spider assembly. If the spider cannot be
removed by hand, use a conventional 3-jaw puller as
shown to remove the spider from the clutch assembly.
IMPORTANT
Do not pull on the outer fingers of the spider or damage
may occur. Position 3 jaw puller in the positions shown
6.12
u
.
ROLLER, PIN, AND THRUST WASHER
INSPECTION
e
1. Inspect all rollers , roller pins
q
and roller caps by pulling a flat metal rod across
the roller.
2. Turn roller with your finger. If you notice resistance,
galling, or flat spots, replace all the rollers.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
r w
, roller washers
© Copyright Polaris Industries Inc.
,