Polaris RZR PRO XP 2020 Service Manual page 195

12. Install zip ties retaining fuel lines and harnesses to
intake manifold.
13. Connect harness going to TBAP, both TMAP sensors,
CPS, coolant temp sensor, Trans switch, speed
sensor, injectors, ETC.
14. Connect the fuel line at the fuel rail.
15. Connect the valve cover vent line.
16. Connect stator harness.
17. Install the coolant hose to the thermostat housing and
the water pump hose.
18. Install the two hoses going to charge air cooler.
19. Install air box and engine air intake. Torque fasteners
to specification.
TORQUE
Air Box Mounting Fasteners:
8 ft-lb (11 Nm)
Intake Clamps:
49 in-lb (6 Nm)
20. Install head pipe/turbo assembly. See Head Pipe /
Turbo Installation page 3.19.
21. Install rear fenders/fender flares. Torque fasteners to
specification.
TORQUE
Rear Fender/Fender Flare Fasteners:
7 ft-lbs (10 Nm)
22. Install cargo box. Torque fasteners to specification.
TORQUE
Cargo Box Fasteners:
7 ft-lbs (10 Nm)
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
ENGINE / COOLING SYSTEM
23. Install ROPS. For proper reinstallation and torque
information, reference Cab Frame Assembly page
11.3.
WARNING
The ROPS should only be serviced by a certified
Polaris dealer.
24. Fill coolant reservoir. Bleed system as required. See
Cooling System Bleeding page 2.38.
25. Check and fill engine oil as required. See Engine Oil
Level page 2.28.
26. Connect the battery. Torque fasteners to
specification.
TORQUE
Battery Fasteners:
60 in-lbs (7 Nm)
3
3.51