Polaris RZR PRO XP 2020 Service Manual page 397

Hide thumbs Also See for RZR PRO XP 2020:

Table of Contents

10. Inspect he AWD coil located in the outer cover plate

assembly. Refer to AWD diagnosis for detailed

inspection process. Replace the cover plate seal and

11. Remove the roll cage assembly and rollers from the

clutch housing. Use a shop towel to cover the

housing in order to retain all the rollers.

Rollers are spring loaded. Take care not to allow them

to fall out or lose them upon removal of the roll cage.

12. Thoroughly clean all parts and inspect the rollers

for nicks and scratches. The rollers must slide up,

down, in and out freely within the roll cage

surfaces and H-springs.

Refer to the "Electronic Parts Catalog" for individual

part availability. Most parts are to be replaced as an

assembly or as a complete kit.

13. Inspect clutch housing / ring gear

wear pattern. Inspect the ring gear for chipped,

broken, or missing teeth.

9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual

14. Inspect the roll cage assembly sliding surfaces and

free of nicks, burrs, or scratches. If damaged, replace

the roll cage assembly.

15. Inspect both output hub assemblies. Inspect the

bearings and replace if needed.

16. Clean and inspect all remaining front gearcase

components. Check each for excessive wear or

for a consistent

. The sliding surfaces must be clean and

Thrust Bearing

Roller Surface

Chapters

Table of Contents