Polaris RZR PRO XP 2020 Service Manual page 366

Hide thumbs Also See for RZR PRO XP 2020:

Table of Contents

REAR BEARING REPLACEMENT

Bearing Removal

1. Remove the outer snap ring

2. Press bearing out using a hydraulic press and

appropriately sized adapter.

3. Inspect the bearing carrier housing for scratches,

wear or damage. Replace rear bearing carrier if

Bearing Installation

4. Thoroughly clean the rear bearing carrier housing

and the outer race on the new bearing. Be sure that

all oil and Loctite residue has been removed from

each surface.

5. Support the bottom of the bearing carrier housing.

Use an arbor and press only on the outer race,

otherwise bearing damage may occur.

6. Apply Loctite

bearing race

7. Carefully press the new bearing into the bearing

carrier housing

Use care to not allow any of the Loctite

get in the bearing.

8. Wipe the housing clean of any excess compound

and install the snap ring

9. Allow Loctite to cure for at least 3 hours before

vehicle operation.

9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual

to the circumference of the new

Chapters

Table of Contents