Driven Clutch Assembly - Polaris RZR PRO XP 2020 Service Manual

PVT SYSTEM
4. Use a pry bar located between the fingers of the Helix
to turn the Helix counterclockwise. Turn until bushing
bottoms out.
IMPORTANT
Only light force is needed to install the bushing. Do not
increase pressure after bushing bottoms out, or
damage may result to bushing.
5. Remove nut and spacer adapter from puller rod. Re-
move Helix and bushing adapter from puller rod.

DRIVEN CLUTCH ASSEMBLY

q
1. Re-install washer , roller
clip is fully seated and roller rotates freely.
t
2. Install clutch spring
r
helix
. Ensure the clutch spring is fully seated.
6.36
w e
, and e-clip Ensure e-
y
and clutch spring cap on the
3. Re-install the retaining fasteners
i
sheave onto the helix
orientation.
IMPORTANT
Using previous hole orientation will ensure the driven
clutch maintains balance.
4. Using clutch compressor PU-50518 compress the
driven clutch assembly.
The helix cover is loaded by the spring. Not using a
proper compressor may result in personal injury or
damage to the clutch.
5. Torque the three T50 torx fasteners
specification.
TORQUE
Helix Fasteners:
32 ft-lbs (44 Nm)
6. Once back together, verify the alignment marks made
during disassembly are properly aligned.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
u
and movable
o
using previous hole
CAUTION
a
to
© Copyright Polaris Industries Inc.