MAINTENANCE
PVT / FINAL DRIVE / WHEEL AND TIRE
PVT DRAIN
If water is ingested into the PVT system:
1. Remove the clutch cover drain plug
2. Allow the water to drain out. Reinstall the plug.
3. Place the transmission in Park. Apply the brakes.
4. Start the engine and apply varying throttle for 10-15
seconds to expel any moisture from the PVT and air
dry the belt and clutches.
Do not hold the throttle wide open for more than 10
seconds.
5. Allow the engine RPM to settle to idle speed. Apply
the brakes. Shift the transmission into Low.
6. Test run the vehicle for slippage. If the belt slips,
repeat steps 1-5.
2.42
q
.
CAUTION
PVT INTAKE PRE-FILTER SERVICE
It is recommended that the PVT intake pre-filter be
inspected daily. The filter should be inspected using the
following procedure:
1. The PVT intake pre-filter is located just above the left
rear wheel fender.
2. Inspect the pre-filter on the outboard
w
sides. If necessary, clean with soapy water and air
dry.
Compressed air or high pressure hose may damage the
pre-filter material on the intake.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
q
and inboard
CAUTION
© Copyright Polaris Industries Inc.