Polaris RZR PRO XP 2020 Service Manual page 383

r
4. Remove four fasteners
t
mounting plate .
5. Disconnect prop shafts from each other. Remove
middle prop shaft, and front prop shaft through the
bottom of the vehicle.
6. Mark prop shafts for reassembly.
NOTICE
The prop shafts have a master spline and will only go
on one way.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
from each prop shaft
y
7. Remove two fasteners retaining each prop shaft
bearing to its mounting plate. Take to avoid incorrect
installation, mark each plate as "front plate" or "rear
plate".
8. Remove the two fasteners retaining roll hoop to the
frame. Remove roll hoop.
9. Remove rear prop shaft through the bottom of the
vehicle.
FINAL DRIVE
8
8.25