Shift Cable Adjustment - Polaris RZR PRO XP 2020 Service Manual

TRANSMISSION

SHIFT CABLE ADJUSTMENT

1. Locate the shift cable attached to the transmission
case in the right rear wheel well area.
q
2. Inspect shift cable , clevis pin, pivot bushings, and
w
dust boot . Replace if worn or damaged.
3. If adjustment is required, loosen the lower jam nut
and pull the cable out of the mount
t
upper jam nut .
4. Adjust the shift cable so there is the about the same
amount of cable travel when shifting slightly past
HIGH gear than when shifting to PARK.
5. Thread the upper or lower jam nut as required to
obtain proper cable adjustment.
NOTICE
This procedure may require a few attempts to obtain
the proper adjustment.
7.4
6. Once the proper adjustment is obtained, place the
7. Start engine and shift through all gears to ensure the
r
e
to move the
shift cable and upper jam nut into the mount. Tighten
the lower jam nut against the mount.
TORQUE
Shift Cable Jam Nuts:
16 ft-lb (22 Nm)
shift cable is properly adjusted. If transmission still
ratchets after cable adjustment, the transmission will
require service.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.