Rear Bearing Carrier Inspection / Removal - Polaris RZR PRO XP 2020 Service Manual

FINAL DRIVE
9. Torque wheel hub nut
u
new cotter pin . Tighten nut slightly if necessary to
align cotter pin holes. Bend both ends of cotter pin
around end of spindle in different directions.
TORQUE
Wheel Hub Castle Nut:
180 ft-lbs (244 Nm)
10. Install wheel and four wheel nuts. Torque wheel nuts
to specification.
TORQUE
Wheel Nuts:
120 ft-lbs (163 N·m)
11. Rotate wheel and check for smooth operation.
8.6
y
to specification and install a
REAR BEARING CARRIER INSPECTION
/ REMOVAL
1. Elevate rear of vehicle and safely support machine
under the frame area.
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.
2. Check bearings for side play by grasping the top and
bottom of the tire firmly and checking for movement.
The tire should rotate smoothly without binding or
rough spots.
3. Remove the four wheel nuts and rear wheel.
4. Remove the cotter pin
w
hub castle nut . Remove the nut, and cone washer
e
from the rear wheel hub assembly.
5. Remove two fasteners
t
line guide .
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
WARNING
q
and loosen the rear wheel
r
and remove the rear brake
© Copyright Polaris Industries Inc.