Polaris RZR PRO XP 2020 Service Manual page 355

NOTICE
Refer to the exploded view at the end of this chapter as
a reference.
k
1. Install the idler shaft and reverse shaft
into the case.
2. Install the transmission input shaft
g
3. Install idler gear assembly
4. Install rear output shaft assembly
5. Assemble the shift shaft rail if previously
disassembled.
NOTICE
Both shift forks need to be oriented the same way, so
that the shift fork pins are both offset to the same side
of the rail.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
6. Install the shift shaft rail
j
together
h
into the case.
.
f
. 7. Inspect the shift drum for any damage or wear.
8. Install the shift drum into the transmission housing.
s
and shift forks into the
transmission housing as an assembly. Be sure the
shift forks are engaged into the engagement dogs.
NOTICE
Shift fork pins should be offset towards the input shaft
as shown.
Inspect the splines of the shift drum.
Lift up on the shift shaft rail and move the rail
assembly towards the shift drum to allow the shift fork
ends to be installed into the shift drum.
TRANSMISSION
7
7.17