Valve Sealing Test; Cylinder Head Installation - Polaris RZR PRO XP 2020 Service Manual

ENGINE / COOLING SYSTEM
11. Install the valve tappet
they were removed.
NOTICE
Oil the tappet prior to installing.
If any valve train components were replaced, refer to
Valve Clearance Adjustment page 2.31.

VALVE SEALING TEST

1. Clean and dry the combustion chamber area
2. Pour a small amount of clean solvent into each intake
w
port and check for leakage around the valves. The
valve seats should hold fluid with no seepage.
3. Repeat for exhaust valves by pouring fluid into each
e
exhaust port .
3.92
i
for each valve in the order
q
.

CYLINDER HEAD INSTALLATION

1. If necessary, rotate the engine so the cylinder is
facing up.
2. If installed, remove the Cylinder Holding & Camshaft
q
Timing Plate from the cylinder.
NOTICE
Once the cylinder head is removed, nothing retains the
cylinder to the engine. DO NOT rotate the engine
without using the Cylinder Holding & Camshaft Timing
Plate (PU-50563).
3. Prepare cylinder head gasket sealing surfaces by
cleaning thoroughly to remove all residue. The head
gasket must be installed clean and dry, free from oil
or grease.
NOTICE
Do not touch the gasket sealing surfaces.
w
4. Guide cam chain through a new head gasket
and install the gasket on the cylinder, locating it on
the alignment pins.
5. Carefully set the cylinder head
alignment pins.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
e
r
in place on
© Copyright Polaris Industries Inc.