Clutch Assembly - Polaris RZR PRO XP 2020 Service Manual

PVT SYSTEM
5. Turn clutch cover counterclockwise on puller rod until
bushing is seated.
6. Remove nut from puller rod. Take installation tool and
clutch cover off rod.

CLUTCH ASSEMBLY

NOTICE
The Teflon® bushings are self-lubricating.
Do not apply oil or grease to the bushings.
Reassemble the drive clutch in the following sequence.
Be sure the "X", or the marks that were made earlier are
aligned during each phase of assembly.
q
1. Install two washers
e
spacer onto the stationary sheave in the order
shown.
6.30
CAUTION
w
, needle bearing , and clutch
2. Install clutch spider as shown
NOTICE
If necessary, once the splines are aligned properly, an
arbor press may be used to properly seat the clutch
t
3. Install washer , belleville washer
u
spring .
IMPORTANT
Belleville washer must be installed with dome facing the
outer post.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
r
.
spider.
y
, and clutch
© Copyright Polaris Industries Inc.