Engine Service; Starter Motor Removal - Polaris RZR PRO XP 2020 Service Manual

ENGINE SERVICE

STARTER MOTOR REMOVAL

1. Remove driver's seat and disconnect the battery.
2. Remove drive and driven clutches (see Drive Clutch
Removal page 6.7 and Driven Clutch Removal page
6.31 in the PVT System chapter).
q
3. Remove six fasteners and remove the inner PVT
cover baffle.
4. Support the bottom side of the engine with wood
blocks or from the top side with an engine lift.
5. Remove the three allen screws
retaining inner cover to engine.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
6. Remove fasteners
7. Discard PVT inner cover o-ring around the crankshaft
8. From the RH wheel well using an 8mm flex socket,
w e
and washers
The (-) negative battery cable is mounted to the engine
9. Remove the starter from the engine.
Tilt the engine slightly forward to gain enough clearance
ENGINE / COOLING SYSTEM
r
and washers
cover to transmission.
snout.
remove the negative battery cable nut
y
cable nut and the two fasteners
starter motor to the engine.
NOTICE
using the upper starter mounting bolt / stud.
NOTICE
to remove the starter.
t
retaining inner
3
u
, positive
i
securing the
3.41