Digital Wrench® Communication Errors; Digital Wrench® - Diagnostic Connector - Polaris RZR PRO XP 2020 Service Manual

GENERAL INFORMATION
4. Once the installation is complete, launch the Digital
Wrench® software and verify the information in the
lower, right-hand corner matches the new Base
Version you just installed.
DIGITAL WRENCH® COMMUNICATION
ERRORS
If you experience problems connecting to a vehicle, or
any other Digital Wrench® software-related problem, visit
the Digital Wrench® home page (www.polaris.diagsys.
com) and locate the following information under
Knowledge Base:
• Errors and Troubleshooting
• Frequently Asked Questions (FAQs)
• Procedures and Solutions
DIGITAL WRENCH® - DIAGNOSTIC
CONNECTOR
The diagnostic connector is located under the storage
tray below the middle seat and is connected to a sealed
plug. To access the diagnostic connector lift up the
passenger seat and remove the storage tray.
Follow these steps to connect the diagnostic interface
cable to the vehicle to allow Digital Wrench® use:
1.40
1. Assemble the MultiLink Module and attach the PC
Interface Cable to your laptop.
2. Remove the protective cap from the Digital Wrench®
connector.
3. Connect the Vehicle Interface Cable to the Digital
Wrench® diagnostic connector.
4. Turn the ignition key to the 'ON' position, select the
appropriate vehicle and wait for the status to display
'Connected' in the lower left corner of the screen.
5. Once connected, proceed with using Digital
Wrench®.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.