Driven Clutch Removal - Polaris RZR PRO XP 2020 Service Manual

DRIVEN CLUTCH REMOVAL

q
1. Loosen the clamp retaining PVT inlet duct to the
outer clutch cover.
2. Remove fourteen fasteners
clutch cover. Remove the clutch cover.
NOTICE
Outer cover fasteners are captured fasteners and will
remain in the outer cover when loosened.
3. Mark the drive belt direction of rotation so that it can
be installed in the same direction.
4. Insert clutch spreader tool
and turn the tool clockwise to open the sheaves on
the driven clutch.
NOTICE
The driven clutch spreader tool is included with the
vehicle's tool kit
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
w
that retain the outer
e
into the driven clutch
5. Walk the belt out of the driven clutch and drive clutch.
Remove the belt from the vehicle.
6. Remove the driven clutch retaining bolt
y
and shim .
7. Remove the driven clutch from the transmission input
shaft by holding both sheaves together and pulling
straight off.
CAUTION
The driven clutch will become damaged if it is dropped.
PVT SYSTEM
r t
, washer ,
6
6.41