Initial Priming / Starting Procedure - Polaris RZR PRO XP 2020 Service Manual

Hide thumbs Also See for RZR PRO XP 2020:

Table of Contents

EFI / FUEL SYSTEM

INITIAL PRIMING / STARTING

The injection system should be purged of all air prior to

initial start up any time the fuel system has been

disassembled.

If the fuel system has been completely drained of fuel,

cycle the key switch from OFF to ON two times, waiting

approximately 5 seconds at each ON cycle to allow the

fuel pump to cycle and shut down.

Attempt to start the vehicle normally. If the vehicle does

not start after 5 seconds of cranking, a problem may exist

and should be diagnosed. Verify no trouble codes are set

and that the unit has good fuel pressure at key on.

Accurate testing of EFI components is recommended

utilizing the Digital Wrench® Diagnostic Software

(dealer only).

9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual

Chapters

Table of Contents