Polaris RZR PRO XP 2020 Service Manual page 373

5. Apply Loctite® 680 to the hub-side splines of the
drive shaft. Apply Loctite® 680 around the entire
circumference of the end of the hub-side splines, and
then apply Loctite® 680 in a spiral pattern as shown.
CAUTION
Use caution to avoid getting Loctite® on the drive shaft
threads or castle nut.
6. Insert rear drive shaft into the bearing carrier/hub
assembly.
NOTICE
Hub assembly hidden for image clarity
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
r
7. Install NEW cone washer
with domed side facing out, and NEW castle nut.
Torque castle nut to specification. Install NEW cotter
t
pin . Tighten nut slightly if necessary to align cotter
pin holes. Bend both ends of cotter pin around end of
spindle in different directions.
TORQUE
Rear Hub Castle Nut:
180 ft-lbs (244 Nm)
8. Install the radius rod bolts, washers and new nuts.
Torque fasteners to specification.
TORQUE
Radius Rods to Bearing Carrier:
52 ft-lbs (70 Nm) + 90°
9. Install wheel and four wheel nuts. Torque wheel nuts
to specification.
TORQUE
Wheel Lug Nuts:
120 ft-lbs (163 Nm)
FINAL DRIVE
e
into the hub assembly
8
8.15