Prodigit 3270 Series Operation Manual page 95

86 PRODIGIT
3.5.3.2. TEST MODE
Press the SHIFT and SEQ. key simultaneously to enter the AUTO SEQUENCE
Mode, and press UP or DOWN key to TEST function, To use the key pad to
setting 1~9 for F1 to F9 and press ENTER key to execute the automatic test
mode.
To execute the automatically test mode the LCD display will display "SXX", S
means step and XX means step no(step 1~16) to indicated which step no
under the testing, if the test Result is NG; the LCD display will show "NG"
(flashing) and suspension of the test until user press ENTER key to continue
test or press EXIT key to leave the test mode, the automatically test mode will
be finish when test to the end of step or press EXIT key to leave the test mode.
If all the test steps are OK, the test result is PASS, LCD display will show
"PASS"; if any one step is NG, the test result will be FAIL; LCD display will
show "FAIL", If the beeper ON/OFF is set to ON, when the test result is PASS
the beeper will beep one sound, if the test result is FAIL, the beeper will beep 2
sounds.
When the test is finished, user can press the ENTER key again to test or press
EXIT key to leave the test mode.
Example 1: The test step setting to 16 step, press the TEST key, the execute
result is PASS, the LCD display shown PASS.