Table 4-9 Module For Each Series - Prodigit 3270 Series Operation Manual

112 PRODIGIT
4.7.3. STAGE Set and read the status of Load
[STATe:] LOAD {SP}{ONOFF}
Syntax: [STATe:] LOAD {SP}{ONOFF}{;NL}
Purpose:Set and read the status of Sink Current or not
Description:This command is used for setting the status of Sink Current . When setting it
[STATe:] MODE {SP}{CCCRCVCP}
Syntax:
Purpose:Set and read the mode of LOAD
Description：Load is acting under these four modes as the following TABLE 4-9. When
Mode
(value)
3270 series
[STATe:] PRESet {SP}{ONOFF}
Syntax: [STATe:] PRESet {SP}{ONOFF}{;NL}
Purpose:Set the left or right digit multi-function meter to display the programming load
Description:This command is for select the left 5 digit LCD display to show current
Pres ON:To select the LCD display to shows current setting
Pres OFF:To select the LCD Display is 〝DWM〞
[STATe:] SENSe{SP}{ONOFF }
Syntax: [STATe:] SENSe{SP}{ONOFF }{;NL}
Purpose：Set and read the Load voltage to read whether is carried by the VSENSE or
Description：This command is for setting the Load voltage to read whether is carried by
[STATe:] LEVel {SP}{AB} or LEV {SP}{AB}
Syntax: [STATe:] LEVel {SP}{AB }{;NL}
[STATe:] LOAD {?}{;NL}
to ON, the Load is going to sink current from appliance. When setting it to
OFF, the Load would not act.
[STATe:] MODE {SP}{CCCRCVCP}{;NL}
[STATe:] MODE {?}{;NL}
reading the Loading Operation mode, the return value 0│1│2│3│4 are
meant to be CC│LIN│CR│CV│CP
CC LIN
0 1
V V

Table 4-9 module for each series

[STATe:] PRESet {?} {;NL}
level.
setting or DWM.
[STATe:] SENSe {?} {;NL}
not.
VSENSE or INPUT Connector. When setting for ON, the voltage is got
from VSENSE, and setting for OFF, the voltage is got from INPUT
Connector.
[STATe:] LEVel {?} {;NL}
[STATe:] LEV{SP}{AB}{;NL}
CR CV CP
2 3 4
V V V