Prodigit 3270 Series Operation Manual page 67

58 PRODIGIT

FUSE CC : setting the fuse current point, the Left 5 digit monitor display the
"FUSE" ,the right upper 5 digit monitor display the "CC", and right lower monitor
display setting value, the unit is "A", Use the knob and button to set the FUSE CC
current value the range from 0.000A to full scale current of the CC mode
specification.

FUSE TIME: setting the fuse test time, the Left 5 digit monitor display the
"FUSE" ,the right upper 5 digit monitor display the "TIME", and right lower monitor
display setting value, the unit is "S". Use the knob and button to set the range from
0.1S ~9999.9S.
Note: If the TURBO is ON, the maximum settable time is one second.

FUSE REP: setting the fuse test times, the Left 5 digit monitor display the
"FUSE" ,the right upper 5 digit monitor display the "REP.", and right lower monitor
display setting value. Use the knob and button to set the range from 0 to 255.

The right upper 5 digit monitor display the TYPE and right lower monitor display
"TRIP" ,use the knob and the key to TRIP or NTRIP.
• The BATT parameters setting:
Pressing the Item key once will cause the button to illuminate. The message
"BATT PRESS START" will be shown across the displays.
Each press of the setting button moves the menu on one step. The Left and right
LCDs show the currently selected test parameter as text. The value is adjusted by
The rotary knob and can be read from the Right display during Setting.
The setting sequence is shown below:
BATT PRESS START
BATT MODE CC
BATT CC
BATT CF
BATT PF LEAD
BATT PF
BATT TIME
BATT VTH







