Prodigit 3270 Series Operation Manual page 59

50 PRODIGIT
•
The SHORT parameters setting:
The SHORT test will attempt to sink high current up to the 3270 series AC/DC load
Maximum current in order to check the power source's protection and behavior.
The test time can be adjusted and threshold values for the High and low voltage
Limits set.
Pressing the Item key once will cause the button to illuminate. The Message
"SHORT PRESS START" will be shown across the displays.
Each press of the Setting key moves the menu on one step. The left and right LCDs
show the currently selected test parameter as text. The value is adjusted by the
Rotary knob and can be read from the right display during Setting.
The setting sequence is shown below:
SHORT PRESS START
SHORT TURBO
SHORT Time CONTI
SHORT V HI
SHORT V Lo

The right upper 5 digit monitor display the Turbo and right lower monitor display
"OFF" ,use the knob and the key to switch ON or OFF.

The setting short test time, right upper 5 digit monitor display the TIME and right
lower monitor display "CONTI", the setting range is "CONTI" means continue.




