Prodigit 3270 Series Operation Manual page 114

ON: ANG
Syntax: [ PRESet:] ON:ANG {SP}{NR2}{;NL}
[ PRESet:] ON:ANG{?}{;NL}
Purpose：Set and Read the loading angle control.
Description: Supports the loading angle control, the full range of 0-359 degree.
OFF: ANG
Syntax: [ PRESet:]OFF:ANG{SP}{ NR2}{;NL}
[ PRESet:]OFF: ANG {?}{ ;NL}
Purpose：Set and read the unloading angle control.
Description: Supports the unloading angle control, the full range of 0-359 degree.
CCCURR: AB
Syntax: [ PRESet:] CCCURR:{AB}{SP}{ NR2}{;NL}
[ PRESet:] CCCURR:{AB} {?} {;NL}
Purpose： Set and read the current of A or B.
Description: This command is for setting the required Load current. And this
Command must be followed the next notices:
1. Level A load and Level B load current settings are independent.
2. The unit is A.
CP :{ AB}
Syntax: [ PRESet:] CP:{ AB}{SP}{ NR2}{;NL}
[ PRESet:] CP: {AB} {?} {;NL}
Purpose：Set and read the value of Watt
Description：This command is for setting the required value of Watt, and the unit is W.
CRRES: {AB}
Syntax: [ PRESet:] CRRES:{ AB}{SP}{ NR2}{;NL}
[ PRESet:] CRRES: { AB} {?} {;NL}
Purpose:Set and read the value of Resistance
Description:This command is used for setting the required value of Load Resistance.
And this command must be followed the next notices:
1. Level A load and Level B load resistance settings are independent.
The unit is Ω.
2.
CVVOLT: {AB}
Syntax: [ PRESet:] CV:{AB} {SP}{ NR2}{;NL}
[ PRESet:] CV:{AB} {?} {;NL}
[ PRESet:] VOLT:{ AB}{SP}{ NR2}{;NL}
[ PRESet:] VOLT:{AB}{?} {;NL}
Purpose:Set and read the value of Voltage
Description:This command is for setting the required value of Voltage, and the unit is V.
3270 Series Operation Manual 105