Front Panel Removal - Agilent Technologies 83620A Service Manual

2. Front Panel Removal

Refer to Figure 7-4.
1. Complete \1. Preliminary Steps" before continuing.
2. Remove of the four screws under the trim strip.
three
3. Remove of the three screws on the lower front frame edge.
two
4. Gently pry the front panel and display from the frame.
If you are removing the front panel only so that you can lift
Note
up the RF deck and if you have a at surface in front of the
synthesizer on which to lay the front panel, let the front panel
lie in front of the synthesizer with all the cables connected and
continue with step 1 of \2. Lift Up the RF Deck". If you do
not have a at surface for the front panel, disconnect ribbon
cables W2 and W3 from the motherboard and lay the front
panel on top of the synthesizer.
7-8 Disassembly and Replacement Procedures
Front Panel
All manuals and user guides at all-guides.com
HP 8360