Changing Working Data Calibration Constants - Agilent Technologies 83620A Service Manual

5. Close A15S1 switch 5 (set the switch to the
6. urn on line power to the synthesizer and press
he asterisk on the
cannot access the adjustment menu.
If you have forgotten the password and wish to set a new one, perform steps 1
through 3 and then steps 7 through 10.
7. On the synthesizer, select
he following message is displayed:
8. Enter the desired password using the numeric keypad. Up to 14 numeric
digits are allowed. erminate the entry by pressing:
9. A warning message is displayed informing you that the adjustment
menus will no longer be accessible. o verify that you do wish to set the
password, select
Yes, Confirm
10. Another warning message is displayed informing you that the A15S1 switch
5 is set open. Complete steps 4 through 6 to close the switch and enable
the password.

Changing Working Data Calibration Constants

If you need to modify the working data calibration constants, the following
procedure accesses the calibration constants and lets you change them.
1. On the synthesizer, set:
Adjust Menu Calib Menu
SERVICE
5
2. Select
.
elect Cal
Enter the number of the calibration constant you wish to change using the
up/down arrow keys, the rotary knob, or the numeric keypad. erminate
numeric keypad entries by pressing
3. Select
.
Modify Cal
4-6 Calibration Constants
All manuals and user guides at all-guides.com
softkey turns on indicating that you
Disable Adjust
Disable Adjust
SET P SSWORD: 0
.
.
.
ENTER
5
0 position).
" "
.
SERVICE
5
.
.
ENTER
5
HP 8360