Removing Rf Output Connector - Agilent Technologies 83620A Service Manual

Figure 7-32. Removing RF Output Connector
When you re-attach the connector and cable to the synthesizer,
Note
rst loosen the nut between cable W43 and the connector.
hen reverse steps 1 through 3. Finally, torque the nut
between cable W43 and connector J1 to 10 in-lb (112 N-cm).
4. Reinstall the front panel.
5. Carefully disconnect cable W48 from the rear panel SMA connector W14
(it's a close t { watch out that you do not damage the cable center
conductor).
6. Disconnect cable W51 (see Figure 7-33) from the low pass lter FL2
(you may need to loosen the other end of W51 also).
7. Remove the two hex screws from the RF deck.
7-48 Disassembly and Replacement Procedures
RF Deck
All manuals and user guides at all-guides.com
HP 8360