All manuals and user guides at all-guides.com
Automated Tests
Introduction
his chapter explains how to load and run the \HP 8360 Service Support
Software" revision A.01.31. Revisions lower than A.01.31 are not compatible
with instruments with Option 006. hese tests require operator interaction.
his software requires that the synthesizer is set to the SCPI programming
language. his is set by the rear panel switch or by the front panel. Refer to
the \Installation" chapter of the
After using the software, return the synthesizer to its original setting.
his chapter contains the following information on using the software:
Setting Up the System
Installing the Software
Running the Software
Reporting Software Bugs
Automated Performance ests
Step Attenuator Flatness est
Power Flatness and Accuracy est
Automated Adjustments
Step Attenuator Flatness Adjustment
YO Delay Adjustment
ADC Adjustment
Power Flatness Adjustment
Utilities
Front Panel Emulation
Calibration Constants
Self- est
Power Sensor Conguration and Calibration Factor File
HP 8360
for further information.
User's Han book
5
Automated Tests 5-1