Installing The Software; Disk Files; Make Working Copies; Installing The Program Onto A Hard Disk - Agilent Technologies 83620A Service Manual

All manuals and user guides at all-guides.com
Refer to the BASIC user's documentation for instructions on loading the
operating system and binaries.

Installing the Software

Disk Files

he automated tests are provided on two double-sided disk. Previous revisions
may be di erent.

Make Working Copies

Before doing anything else, make a working copy of the master disks!
ype: INI IALIZE \Address of drive containing blank oppy"
he master disk is shipped from the factory write-protected and cannot be
written to or initialized in this mode. We recommend you maintain this master
disk in write-protect mode. During execution of some tests, the program reads
from and writes to the disk, use a working copy that is not write-protected
when you run the software.
Installing the Program onto a ard Disk
We recommend that you run the software from a hard disk. It is possible
to operate it from a single or dual oppy disk drive, however speed will be
sacri ced.
o install the program onto your hard disk, create a directory that will contain
the program and its associated les. (Refer to the BASIC user's documentation
for instructions on creating directories.) After you create the directory, run the
install program below to load all of the les onto your hard disk.
1. Insert master disk #1 into the oppy disk drive.
2. ype: COPY \OPV 8360:,700,0" O \/ ES /OPV 8360:,1400,0"
3. Remove master disk #1 and insert master disk #2 into the disk drive.
HP 8360 Automated Tests 5-3