4. ype LOAD \COPY DISK:,700,0"
5. Press RUN and follow the prompts to copy all les from the second master
disk to the hard disk. In this example, the source location is :,700,0 and the
destination location is :,1400,0
Your hard disk is now set up to run the automated tests.
Operating from a Floppy Disk
When you run the software from a
oppy disk drive, be sure to leave the
second master disk in the disk drive while the program runs. If this is not
done, the program will not run.
Running the Software
his software uses RAM memory volumes for fast access of
CAUTION
data les. hese volumes may also be used by other programs
and could contain data that will be erased by this program.
Make sure that the computer you are using does not have
important data in any memory volumes before running this
software.
Configuration Limitations
he computer containing the software must be the
If more than one controller is present, the software will not run properly.
Loading the Software
1. Make sure the software has been copied into a directory (if running from a
hard disk) or copied to a work disk (if running from a
oppy disk).
2. Set the default mass storage to the directory or
oppy disk that contains the
test software. Use the BASIC MSI command. See the BASIC
for more information on setting the default mass storage.
Reference
5-4 Automated Tests
All manuals and user guides at all-guides.com
controller on the bus.
only
Language
HP 8360