Front Differential Limit Switch Installation; Fuel Level Sending Unit; Testing The Fuel Level Sending Unit - Club Car Carryall 295 Maintenance And Service Manual
Hide thumbs
Also See for Carryall 295:
- Maintenance and service manual (456 pages) ,
- Owner's manual (72 pages) ,
- Owner's manual (84 pages)
Table of Contents
Advertisement
14
Fuel Level Sending Unit
2496
Figure 14-10 Front Differential Limit Switch Removal
FRONT DIFFERENTIAL LIMIT SWITCH INSTALLATION
1.
Install the front differential limit switch (1) in the reverse order of removal and tighten the nuts (2) to 4 in-lb (0.5
N·m) (Figure 14-10, Page 14-14). See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are overtightened, the switch could become damaged.
2.
Move the accelerator pedal back and forth to ensure that the switch lever is being properly activated.
3.
Connect wire leads of switch to wire harness.
4.
Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
FUEL LEVEL SENDING UNIT
See General Warnings, Section 1, Page 1-2.
Thoroughly test the fuel level sending unit before replacing the unit.
TESTING THE FUEL LEVEL SENDING UNIT
See Test Procedure 31 – Fuel Level Sending Unit on page 12-37.
Page 14-14
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
ELECTRICAL COMPONENTS: DIESEL VEHICLES
1
2
Advertisement
Table of Contents
Troubleshooting
