Club Car Carryall 295 Maintenance And Service Manual page 110

8
Front Hubs
8
2
1
2
4
1899
Figure 8-2 Position Steel Blocks and Upright on Press
3. Press the bearing out of the upright.
3.1. Position the upright (5) with the two ball joint arms down on one steel block (1) and the drag link arm down
on a second steel block (1) (Figure 8-3, Page 8-4).
Press ram
10
1
2030
3.2. Shim the ball joint arms with steel blocks (2 and 3) to provide a level surface for bearing removal (block 2
height is 9/16 inch and block 3 height is 1-11/16 inch).
3.3. Make special bar (10), that fits inside cutouts of the bearing cavity opening (7), to rest on the outer race of
the bearing. Press out bearing.
Page 8-4 2013 Carryall 295/XRT 1550 Maintenance and Service Manual
7
5
6
1
4
7
5
1
Figure 8-3 Bearing Removal
WHEELS, TIRES AND HUBS
2.835 in. (72 cm)
2.909 in. Max. (73.9 cm Max.)
0.281 in.
(7 mm)
10
Radius
0.5 in.
(12 mm)