Coolant Reservoir; Coolant Reservoir Removal - Club Car Carryall 295 Maintenance And Service Manual

RADIATOR AND COOLANT SYSTEM (DIESEL)

COOLANT RESERVOIR

See General Warnings, Section 1, Page 1-2.

COOLANT RESERVOIR REMOVAL

1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Raise the hood and remove the reservoir cap. See following WARNING.
WARNING
• Coolant reservoir and radiator are pressurized. Remove caps slowly to relieve pressure.
• Hot! Coolant system is pressurized. Do not remove radiator cap while engine is hot.
3. Place a large drain pan under the radiator and front differential to collect coolant. See following NOTE.
NOTE: Do not remove the drain pan until the reservoir has been replaced and the hoses attached.
4. Turn the drain valve at the radiator counterclockwise, for one and one-half turns only, to drain enough coolant to
empty the reservoir. Once empty, close radiator drain valve. See following NOTE.
NOTE: The radiator drain valve does not have a drain STOP position. It can be removed from the radiator if turned
more than one and one-half rotations.
5. From under the instrument panel, release the clamp securing the 5/8 inch hose to the bottom of the reservoir and
remove hose (Figure 18-3, Page 18-3).
6. Release the clamps securing the two hoses at top of reservoir and remove hoses.
7. Remove the two bolts securing reservoir to chassis. Access to rear bolt is from under the instrument panel.
Access to the other bolt is between the reservoir and fender.
8. Lift up rear of reservoir to clear mounting tab of chassis and pull reservoir forward and up to remove.
1
3
1. Clamps 2. Mounting Points 3. 5/8" Hose Clamp
2218
Figure 18-3 Reservoir Hoses And Mounting Points
2
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
18
Coolant Reservoir
Page 18-3