Attachment Arm Float Switch - Club Car Carryall 295 Maintenance And Service Manual
Hide thumbs
Also See for Carryall 295:
- Maintenance and service manual (456 pages) ,
- Owner's manual (72 pages) ,
- Owner's manual (84 pages)
Table of Contents
Advertisement
HYDRAULIC ATTACHMENT SYSTEM
– Continuity from the 14-gauge red wire (w08) at the Accessory Relay to the 16-gauge orange/black wire
(w10) at the ON/OFF switch.
– Continuity from the 16-gauge orange wire (w81) at the ON/OFF switch to any 18-gauge orange wire at
the joystick.
Joystick ON/OFF Switch Removal
1.
Set the joystick ON/OFF switch to OFF and remove both seats.
2.
Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
3.
Cut the wire tie securing joystick harness to chassis (Figure 19-22, Page 19-11).
4.
Access the joystick ON/OFF switch. See Joystick Removal on page 19-11.
5.
Ensure the wires are connected correctly and are tight. If they are not, rewire or tighten as necessary.
6.
Unplug harness from switch (Figure 19-22, Page 19-11). Squeeze tabs at each end of switch and push switch
out the back of the control box.
Joystick ON/OFF Switch Installation
1.
Insert switch into control box until fully seated.
2.
Connect harness plug to switch.
3.
Install control box cover/joystick assembly and secure with the four screws.
4.
Secure joystick harness to chassis with new wire tie (Figure 19-22, Page 19-11).
5.
Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
ATTACHMENT ARM FLOAT SWITCH
See General Warnings, Section 1, Page 1-2.
9
2
3
A. Lighted Position B. Rest Position C. Alignment Notches
Terminals:
2. #18 White w75 3. #18 Brown w20
7. #18 Light Blue w46 9. #18 Black w74
2240
Figure 19-24 Float Switch Test (Rear View)
Testing the Float Switch
NOTE: The control circuit is protected by a 20-amp fuse. Check the fuse before this procedure is performed. See
Test Procedure 2 – Fuse on page 12-13.
1.
Remove the float switch. See Float Switch Removal on page 19-14.
2.
Check the following location for no continuity with switch at "rest" and continuity with switch in the ON position
(Figure 19-24, Page 19-13):
– between terminal 2 (white wire w75) and terminal 3 (brown wire w20)
A
7
C
B
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
19
Electrical
Page 19-13
Advertisement
Table of Contents
Troubleshooting
