ELECTRICAL COMPONENTS: DIESEL VEHICLES
BED LIFT SWITCH
TESTING THE BED LIFT SWITCH
See Test Procedure 37 – Bed Lift Switch on page 12-42.
BED LIFT SWITCH REMOVAL
1.
Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2.
Raise the hood.
3.
Press the upper and lower retaining tabs and push the bed lift switch (9) out of the instrument panel (Figure
14-6, Page 14-6).
4.
Disconnect the wire harness from the bed lift switch.
BED LIFT SWITCH INSTALLATION
1.
Match the terminal numbers molded onto the connector and switch and reconnect the wire harness.
2.
Push the bed lift switch into the instrument panel until fully seated.
3.
Lower and secure the hood.
4.
Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
BED LIFT CIRCUIT BREAKER
TESTING THE BED LIFT CIRCUIT BREAKER
See Test Procedure 38 – Bed Lift Circuit Breaker on page 12-43.
BED LIFT CIRCUIT BREAKER REMOVAL
1.
Push the bed lift switch (9) out of the instrument panel. See Bed Lift Switch Removal on page 14-9.
2.
Locate the bed lift circuit breaker (10) on the orange wire of the wire harness connected to the switch (Figure
14-6, Page 14-6).
3.
Pull the circuit breaker out of the in-line fuse holder to remove.
BED LIFT CIRCUIT BREAKER INSTALLATION
Install the circuit breaker in the reverse order of removal.
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
14
Bed Lift Switch
Page 14-9